TMI POWER BLAST© Marker/Clearance light 12-14 Volts DC.
Can be used as single mode or dual mode.
Comes with Three 8-FOOT long wires, Low mode wire for running light, high mode wire for turn signal and ground wire.
(((RICH AMBER))) MARKER CLEARANCE WITH THIRD WIRE FOR DUAL MODE FOR RUNNING AND TURN MODE COMBONATION SURFACE MOUNT LED MARKER/CLEARANCE LIGHTS WITH CHROME PLATED BASE!!!!!
A GREAT LOOKING SIDE/REAR MARKER/CLEARANCE LIGHT FOR TRUCK, TRAILER, MOTORCYCLES, RV, BUS, VAN, ETC.
Size of light: 3.94"(L) x 1.94"(W) x 1.11"(H)
Distance between the two mounting hole centers: 3"
Purchase 1 pc or as many pieces as needed and receive combined shipping.
TMI Dual Mode POWER BLAST© Marker Lights
Each light contains 12-leds inside.
Each light comes with three 8-foot lead wires for easy hookup.
Each light includes two screws for fast and quick surface mounting
TMI AMBER Marker Light Offers: Running-Turn Modes.
TMI Red Marker Light Offers: Tail-Stop-Turn Modes.
|
Dual TM36-1Y/C (AMBER)
|
Dual TM36-1R/C (RED)
|
Super Bright TM36-12R/C and TM36-12Y/C Dual mode Double Bubble Lights
Customer Pride and Joy
Photo taken by Gerald
QUALITY MADE
TMI Marker light turn signal light Combination
Why just have 1 or 2 flashing lights when you can have whole side of the truck or trailer flashing?
NEW
Comes with 2 screws, black foam back, amber lens and clear lens and 8_foot web
wires
This light is QUALITY made
Size of light: 3.94"(L) x 1.94"(W) x 1.11"(H)
Distance between the two mounting hole centers: 3"
Backside of the light above is for surface mounting.
EACH LIGHT COMES WITH THREE LEAD WIRES, TWO MOUNTING SCREWS, 1 CLEAR LENS.
Each light Clear Epoxy potted inside and comes with 2 screws for mounting.
|
Light is fully off with Clear lens and Chrome Base
TM36-12Y/C-Dual lights
These lights above and below are using TMI's Clear Lens
TM36-12Y/C-Dual mode lights
Photo above taken with no camera flash
Size of light: 3.94"(L) x 1.94"(W) x 1.11"(H)
Distance between the two mounting hole centers: 3"
|
Order Status