This White LED Light Bar Offers Three Modes:
1. Low mode: (one row 19 leds ON Low)
2. Medium mode: (three rows 59 leds on medium)
3. High mode: (three rows 59 leds on high)
TMI's WHITE Light bars offer a water clear (no color) lens.
The Light bars are fully sealed ( SUBMERSIBLE ) just like our Amber and Red light bars to be Fully Submersible.
Below we show you how bright the white LEDs are and show you the LEDS are not blue looking leds when turned on.
Below you can see the WHITE light bar go from Low to Medium and then High
You can choose your brightness setting at anytime to fit your requirements and run it steady full time on any of the three modes seen below.
Below photos with lens removed:
See above Low, Medium and High modes
See above Low, Medium and High modes
See above Low, Medium and High modes
Below photos with lens sealed to the case:
Light bar seen below is off
Light bar seen below is in low mode using one row of leds.
Light bar seen below is in medium mode using three row of leds.
Light bar seen below is in high mode using three row of leds.
WHITE Led Light Bar Features:
1. 59 LEDs inside of each light bar
2.
Low mode, 1 single middle row, 19 LEDs
3. Medium mode, 3 rows on medium, 59 LED.
4. High mode, 3 rows on High, 59 LED.
5. Each function can operate independently when hooked up....
6. Operational Voltage 12-14.5 Volts DC
7. Power consumption at 12.8V: Low mode one row: 0.062A Medium mode three rows: 0.57
High mode three rows: 0.61
8. Three sections can be used in one single line or any configuration you desire to meet your special requirement or look.
8. Length of light bar from mounting hole to mounting holes 22" (without mounting wings 21.125" long)
9. Width of each bar 1.49 inch
10. Depth of each bar 0.90 inch
11. Length of one light bar end of tab to end of tab 22.25"
12. Total length of two sections end to end 44.50 inches (without mounting wings 42 and 2/8" long)
13. Total length of all three sections end to end 66.75 inches.
14. Simple mounting, comes with 2 screw and 3M double back tape to secure each bar in place.
15. Fully epoxy potted LED's and PCB for long life up to 100,000 hours.
16. Heavy Duty black PC case and water clear lens for truck and trailer applications.
17. Water clear lens made of Hard PC, which makes is impact proof and scratch resistant.
18. Heavy duty electrical cable for long life and protection from wire damage or electrical failures.
19. Designed to be used as front running lights, rear reverse lights/backup lights, inside trailer, truck sleeper home lighting inside or outside the home. l
Order Status